Laboratory for Dynamics of Machines and Structures 
A Sequential Approach to the Biodynamic Modeling of a Human Finger
 L. Knez, J. Slavič and M. Boltežar
Shock and Vibration, Vol. 2017, Article ID8791406, Aug 2017

download pdf   http://doi.org/10.1155/2017/8791406
Povzetek
In an effort to understand the vibration-induced injuries incurred by manual workers, mechanical models are developed and used to predict the biodynamic responses of human body parts that are exposed to vibration. Researchers have traditionally focused on the arms and hands, but there has been only limited research on fingermodeling. To simulate the accurate response of a single finger, a detailed mechanical model based on biodynamic finger measurements is necessary. However, the development of such models may prove difficult using the traditional one-point couplingmethod; therefore, this study proposes a new approach. A novel device for single-finger measurements is presented and used to expose the finger to a single-axial broadband excitation. The sequentially measured responses of the different finger parts are then used to identify the parameters of a multibody mechanical model of the index finger. Very good agreement between the measured and the simulated data was achieved, and the study also confirmed that the obtained index-finger model is acceptable for further biodynamic studies.
Authors

Direktor razvoja

Luka Knez, dr.

  Tehnos d.o.o.
  
  
Scholar Home Xs

Profesor

Janko Slavič, dr.

  Ladisk, Fakulteta za strojništvo, Univerza v Ljubljani
  janko.slavic@fs.uni-lj.si
  +386 1 4771 226
jankoslavic     jankoslavic    
Scholar Home Xs

Profesor

Miha Boltežar, dr.

  Ladisk, Fakulteta za strojništvo, Univerza v Ljubljani
  miha.boltezar@fs.uni-lj.si
  +386 1 4771 608
Scholar Home Xs